Installation & Owners Manual 2017

Blueridge Owners Manual

Document Version: 01/2017

Mount the Outdoor Unit

• Mount the outdoor unit to your choice of a concrete pad, plastic pad, or

wall bracket using the foot holes and bolts.

Connect the Copper Lines

• Remove the screw on the right handle of the outdoor unit.

• Slide the cover down to take the panel off and expose the valves.

• Remove the screw cap of the valves.

• Connect the pipe joint of the outdoor unit with the flared end of the cop-

per line set. If the copper pipes are not flared already, please reference

the Copper Line Flaring section of this document. (See page 54)

• Tighten the union nut (compression fitting) by hand.

Img 11 | Footholes located at the botton of the outdoor unit

Installation of a Multi Zone Outdoor Unit

Foot Holes