Installation & Owners Manual 2017

Blueridge Owners Manual

Document Version: 01/2017

Hex Nut Diameter (in) Tightening Torque (ft-lbs)

1/4 10-13

3/8 25-30

1/2 36-45

5/8 50-60

• If the lines are not already insulated, wrap them with insulation and tape

the insulation in place.

Wiring the Air Handlers to the Outdoor Unit

• Remove the wire clip on the outdoor unit.

• Connect the multi conductor control/power wire that is run from the

indoor air handler to the associating terminals on the outdoor unit. Color

coded multiconductor is highly recommended to ensure that the wires

have been connected correctly.

• It is essential that the multi conductor control/power wire is connected

to the same connection port as the matching copper lines for each zone.

For example, the air handler with copper lines connected to port A, must

also have the multi conductor control/power wiring connected to terminal

block A.

Installation of a Multi Zone Outdoor Unit

• Place the open-ended wrench on the pipe joint and place the torque

wrench on the union nut (compression fitting). Tighten the union nut

according to the chart on the next page: