Installation & Owners Manual 2017

Blueridge Owners Manual

Document Version: 01/2017

NOTE

• Whenever the power is connected, the system is in stand

by mode and you can operate the air conditioner using the

remote control.

• When the unit is on, each time you press a button on the

remote controller, the sending signal icon “ “ on the display

of remote control will blink once. If the air handler beeps, that

means the signal has been received.

15 SEER Unit Remote

1. Once the power is connected, Press the ON/OFF button on the remote

controller to power the unit on.

2. Press the “MODE” button to select your desired mode: AUTO, COOL, DRY,

FAN, HEAT.

3. Press the “+” or “-” button to set your desired temperature. (Temperature

cannot be adjusted under auto mode).

4. Press the “FAN” button to set your desired fan speed: auto, low, medium,

and high speed.

5. Press the “SWING” button to select the fan blowing angle.

Quickstart Operation Guide

On/Off Button

Press the ON/OFF Button to turn the unit ON/OFF

Buttons on Remote Control