Installation & Owners Manual 2017
Blueridge Owners Manual
49
Document Version: 01/2017
Copyright 2017 Alpine Home Air Products
Replacement of batteries in remote control
1. Press the back side of remote
controller on the spot marked
” “, and then pull the cover off
of the battery box.
2. Replace two No.7 (AAA 1.5V) dry
batteries and make sure the +
and - positons are correct.
3. Reinstall the battery box cover
NOTE
• During Operation, point the remote control signal sender at
the receiving window on the indoor unit
• The distance between the signal sender and the receiving
window should be no more than 26 feet, and there should be
no obstacles between them.
• The signal may be interfered in the room where there are fluo-
rescent lamp or wireless telephones.
• Replace both new batteries of the same model when replace-
ment is required.
• If the remote will not be used for a long period of time, re-
move the batteries. Batteries can corrode and cause damage
to the remote if left unused.
• If the display on remote controller is fuzzy or there’s no dis-
play, please replace the batteries.
Cover of Battery Box
Reinstall
Remove
Signal Sender
Battery
Img 17 | Back of High Seer Remote
Multizone, 18, 20, and 22 SEER Remotes