BMKH18M-NDG3 & BMKH30M-NDG3 Owners and Installation Manual
Blueridge Owners Manual
38
Document Version: 11/2016
Copyright 2016 Alpine Home Air Products
15 SEER Unit Remote
Replacement of batteries in remote control
1. Press the back side of remote
controller on the spot marked ” “,
and pull off the battery box.
2. Replace two No.7 (AAA 1.5V) dry
batteries and make sure the posi-
tions or + and - polar are correct.
3. Reinstall the cover of the battery
box.
NOTE
• During Operation, point the remote controller signal sender at
the indoor air handler.
• The distance between signal sender and receiving window
should be no more than 26 feet, and there should be no ob-
stacles between them.
• Signal may be interfered easily in the room where there is flu-
orescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
• Replace both batteries with new AAA 1.5V at the same time.
• To avoid damage to the remote, please remove the batteries if
it won’t be used for a long time.
• If the display on the remote controller is fuzzy or there’s no
display, please replace the batteries
Battery
Reinstall
Remove
Cover of Battery Box
Img 15 | Back of 15 Seer Unit Remote