BMKH18M-NDG3 & BMKH30M-NDG3 Owners and Installation Manual

Blueridge Owners Manual

Document Version: 11/2016

Replacement of batteries in remote control

1. Press the back side of remote

controller on the spot marked

” “, and then pull the cover off

of the battery box.

2. Replace two No.7 (AAA 1.5V) dry

batteries and make sure the +

and - positons are correct.

3. Reinstall the battery box cover

NOTE

• During Operation, point the remote control signal sender at

the receiving window on the indoor unit

• The distance between the signal sender and the receiving

window should be no more than 26 feet, and there should be

no obstacles between them.

• The signal may be interfered in the room where there are fluo-

rescent lamp or wireless telephones.

• Replace both new batteries of the same model when replace-

ment is required.

• If the remote will not be used for a long period of time, re-

move the batteries. Batteries can corrode and cause damage

to the remote if left unused.

• If the display on remote controller is fuzzy or there’s no dis-

play, please replace the batteries.

Cover of Battery Box

Reinstall

Remove

Signal Sender

Battery

Img 17 | Back of High Seer Remote

Multizone, 18, 20, and 22 SEER Remotes