LM Wall Mount User Manual

8
button
button/
●
●
●
●
●
Under cool or heat mode, press this button to turn
to quick cool or quick heat mode. " " icon is
displayed on remote controller. Press this button
again to exit turbo function and " " icon will
disappear.
“
、 、
" may not be available. When air condi-
tioner receives this signal, the air conditioner will blow
fan automatically.
Press "▲" or "▼" button once increase or decrease
set temperature 1℃(1°F). Holding "▲" o r "▼" button,
2s later, set temperature on remote controller will
no display
(horizontal louvers
stops at current position)
change quickly. On releasing button after setting is
finished, temperature indicator on indoor unit will
change accordingly. (Temperature can't be adjust-
ed under auto mode)
When setting TIM ER ON, TIMER OFF or CLOCK,
press "▲" or "▼" button to adjust time. (Refer to
CLOCK, TIMER ON, TIMER OFF buttons)
When selecting " ", air conditioner is blowing
fan automatically. Horizontal louver will automat-
ically swing up & down at maximum angle.
When selecting
、 、
" ",
、 、
air condition-
er is blowing fan at fixed position. Horizontal
louver will stop at the fixed position.
When selecting "
、 、
", air conditioner is
blowing fan at fixed angle. Horizontal louver will
send air at the fixed angle.
Hold " "button above 2s to set your required
swing angle. When reaching your required
angle, release the button.
NOTE
TURBO
button
SWING
button
●
●
Press this button can select up & down swing angle.
Fan blow angle can be selected circularly as below:
Having set X-FAN function on: After turning off the
unit by pressing " " button, indoor fan will continue
running for a few minutes at low speed. In this
period, hold fan speed button for 2s to stop indoor
fan directly.
Having set X-FAN function off: After turning off the
unit by pressing " " button, the compl ete unit will
be off directly.
Under cool or heat mode, press this button to start
up sleep function. " " icon is displayed on
remote controller. Press this button again to cancel
sleep function and " " icon will disappear.
SLEEP
button
●
●
●
●
Outdoor temperature display is not available for some
models. At that time, indoor unit receives " "
signal, while it displays indoor set temperature.
It
's defaulted to display set temperature when turning
on the unit. There is no display in the remote control-
ler.
Only for the models whose indoor unit has dual-8
display.
When selecting displaying of indoor or outdoor ambi-
ent temperature, indoor temperature indicator
displays corresponding temperature and automatical-
ly turn to display set temperature after three or five
seconds.
no display
●
●
●
NOTE
By pressing this button, you can see indoor set
temperature, indoor ambient temperature or
outdoor ambient temperature on indoor unit's
display. The setting on remote controller is selected
circularly as below:
When selecting " " or no display with remote
controller, temperature indicator on indoor unit
displays set temperature.
When selecting " " with remote controller, tem -
perature indicator on indoor unit displays indoor
ambient temperature.
When selecting " " with remote controller,
temperature indicator on indoor unit displays
outdoor ambient temperature.
TEMP