BMKH Low Wall Owners Manual

Table Of Contents

Maintenance

Before inspection and maintenance of the unit. PLEASE set power switch to “OFF” to cut off the

power supply.

3.1 Units

3.2 Filters

CAUTION

● Indoor unit, Outdoor unit and Remote controller

● Front panel

1. Wipe them with dry soft cloth.

1. Open the front panel.

2. Remove the air filter.

Slide the two stoppers on the left and right sides inward until they click.

2. Remove the front panel.

• Remove the string.

• Allowing the front panel to fall forward will enable you to remove it.

3. Clean the front panel.

• Wipe it with a soft cloth soaked in water.

• Only neutral detergent may be used.

• In case of washing the front panel with water,dry it with cloth, dry

it up in the shade after washing.

4. Attach the front panel.

• Insert the front panel into the grooves of the unit (3 places).

• Press the claws on the right and left of the air filter down slightly, then

pull upward.

• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury

• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully

• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.

•

For cleaning, do not use hot water above 104℉, benzine, gasoline, thinner, nor other volatile oils, polishing

compound, scrubbing brushes, nor other hand stuff.

After cleaning, make sure that the front panel is securely fixed.

• Attach the string to the right, inner-side of the front grille.

• Close the panel slowly.

String

Place front

panel in

grooves.

OPERATION INSTRUCTIONS

String

Take off the Air-Purifying Filter.

• Hold the tabs of the frame, and remove the claws in 4 places.