LM Wall Mount User Manual

7
button
button
●
●
●
AUTO COOL DRY FAN
HEAT
Press this button to turn on the unit. Press this button
again to turn off the unit.
●
●
NOTE
Press this button to select your required operation
mode.
Auto
Introduction for buttons on
remote controller
button
Press this button can set fan speed circularly as:
auto (AUTO), low ( ), medium ( ), high( ).
MODE
This is a general use remote controller. It could be
used for the air conditioner with multifunction. For the
functions which the model doesn't have, if press the
corresponding button on the remote controller, the
unit will keep the original running status.
After putting through the power, the air conditioner
will give out a sound. Power indicator " " is ON.
After that, you can operate the air conditioner by
using remote controller.
Under on status, pressing the button on the remote
controller, the signal icon " " on the display of
remote controller will blink once and the air condition-
er will give out a
"di" sound, which means the signal
has been sent to the air conditioner.
Under off status, set temperature and clock icon will
be displayed on the display of remote controller (If
timer on, timer off and light functions are set, the
corresponding icons will be displayed on the display
of remote controller at the same time); Under on
status, the display will show the corresponding set
function icons.
When selecting auto mode, air conditioner will
operate automatically according to ex-factory
setting. Set temperature can't be adjusted and
will not be displayed as well. Press "FAN" button
can adjust fan speed. Press "SWING" button can
adjust fan blowing angle.
●
●
●
NOTE
Under AUTO speed, air conditioner will select proper
fan speed automatically according to factory default
setting.
It
's low fan speed under dry mode.
X-FAN function: Holding fan speed button for 2s in
cool or dry mode, the icon
" " is displayed and the
indoor fan will continue operation for a few minutes in
order to dry the indoor unit even though you have
turned off the unit. After energization, X-FAN OFF is
defaulted. X-FAN is not available in auto, fan or heat
mode.
This function indicates that moisture on evaporator of
indoor unit will be blowed after the unit is stopped to
avoid mould.
FAN
●
●
●
●
NOTE
●
●
For preventing cold air, after starting up heat mode,
indoor unit will delay 1~5 minutes to blow air (Actual
delay time depends on indoor ambient temperature).
●
Set temperature range from remote controller :
●
This mode indicator is not available for some models.
Cooling only unit won't receive heat mode signal. If
setting heat mode with remote cont roller, press
" " button can't start up the unit.
16~30℃(61-86℉); Fan speed: auto, low speed,
medium speed, high speed.
After selecting cool mode, air conditioner will
operate under cool mode. Press "▲" or "▼"
button to adjust set temperature. Press "FAN"
button to adjust fan speed. Press "SWING"
button to adjust fan blowing angle.
When selecting dry mode, the air conditioner
operates at low speed under dry mode. Under
dry mode, fan speed can't be adjusted. Press
"SWING" button to adjust fan blowing angle.
When sele
cting fan mode, the air conditioner will
only blow fan, no cooling and no heating. Press
"FAN" button to adjust fan speed. Press "SWING"
button to adjust fan blowing angle.
When selecting heat mode, the air conditioner
operates under heat mode. Press "▲" or "▼"
button to adjust set temperature. Press "FAN"
button to adjust fan speed. Press "SWING"
button to adjust fan blowing angle.