PTAC Wall Sleeve instructions

HOW TO INSTALL THE DRAIN KIT (CONTINUED)
Install the cover plate with tube to the drain outlet located
at the back of the sleeve by using two screws and install the
cover plate without tube to the other drain outlet by using
two screws as shown below.
NOTE:The cover plate with tube may be placed on either
sied of the sleeve. Before tightening the screws,make sure
the tube s position will allow the sleeve to fit through the
wall.
5
See the following procedures to perform inside drainage.
Attach foam gasket to cover plate as shown below.
Insert the straight tube into the cover plate with drain outlet
as shown below.
HOW TO INSTALL THE DRAIN KIT (CONTINUED)
6
First install the cover plate with tube to the bottom of the
wall sleeve by useng two screws with light strength as
shown below,then fasten tightly two screws at the same
time with not more strong strength to avoid to injure the
tube.
Drill two 1/8-inch holes in suitable position of the bottom
of the wall sleeve to line up with the holes of the cover plate
as shown below. Then drill one 0.4 ~0.5 hole in the middle
of the above two holes as shown below.
Holes of the
cover plate
Install the other two cover plates to the drain outlet located
at the back of the wall sleeve by using four screws as shown
below, fasten tightly and do not make water leak.
2- 1/8
0.4 ~0.5
7
HOW TO INSTALL THE DRAIN KIT (CONTINUED)
NOTE:When you choice the inside drainage ,make sure the
water be leaded to the floor drain or a suitable drainage
facility with a water hose (local purchase) to the straight
tube to avoid water to flow to the indoor floor. The drainage
facility should be lower than the drain outlet of the wall
sleeve.
NOTE:When you choice the outside drainage ,must install
a cover plate without hole to the drain outlet of the bottom
of the wall sleeve by using two screws and make sure water
do not leak as shown below.Make sure the plate's position
will allow the slee
ve to fit through thewall.
CW054I-PTAC(ZDQT) 16120300A00013