PTAC Wall Sleeve instructions

WALL SLEEVE
INSTALLATION INSTRUCTIONS
SLEEVE HARDWARE
ITEM
DESCRIPTION
QT Y
1
BOTTOM COVER
1
2 1
3
4
LEFT COVER
1
1
1
1
INSTALL THE SLEEVE
INSTALL THE SLEEVE (CONTINUED)
2
7
5
6
In
Attach the SEAL A and SEAL B to the SLEEVE at proper
position as shown below.(See Fig.5, Fig.6 and Fig.7)
stall the BOTTOM COVER with the LEFT COVER and
RIGHT COVER together by using 8 short screws as
shown below.(See Fig.3)
REMARK
3 4
TOP COVER
SEAL A
SEAL B
5
RIGHT COVER
6
2
LONG/SHORT SCREW
7
4/14
Fig.3
Install 6 short screws as shown below.(See Fig.2)
Fig.2
Open the LEFT COVER and RIGHT COVER as shown
below.(See Fig.1)
Fig.1
1
2
DRAIN KIT PARTS LIST
ITEM
DESCRIPTION
QT Y
1
COVER PLATE WITH DRAIN OUTLET
1
2
COVER PLATE(optional)
6
3
4
HOW TO INSTALL THE DRAIN KIT
You can choose outside drainage or inside drainage. See the following
procedures to perform outside drainage.
Attach foam gasket to cover plate as shown below.
Insert the bent tube into the cover plate with drain outlet as
shown below.
REMARE
2
5
FOAM GASKET WITH DRAIN OUTLET
1
1
2
3
BENT TUBE(optional)
DRAIN KIT (OPTIONAL)
INSTALLATION INSTRUCTIONS
6
6
6
SCREW ST3.9*14(optional)
STRAIGHT TUBE(optional)
1
4
4 5
Rotate the tube to the proper position as shown below.
First install
INSTALL THE SLEEVE (CONTINUED)
Turn the SLEEVE as shown below.(See Fig.4)
UNIT INSTALLATION
Fig.4
Lift unit level and slide unit into wall sleeve until firmly
against front of wall sleeve and secure with 4 long
screws through the unit flange holes. (See Fig.8 and
Fig.9)
NOTE ,:B 2elow steps only for referenc detail steps
please refer to actual unit.
Fig.8
Fig.5
Fig.9
Fig.6 Fig.7
3
26.4 LONG
1.6 LONG
The top of the SLEEVE
The rear of the top
SEAL A(26.4 LONG)
6
SEAL B(1.6 LONG)
The bottom of the
SLEEVE
The rear of the
bottom
9.3
SEAL B(1.6 LONG)