BPRPGE14 Spec Sheets

PRPGE14
PRODUCT SPECIFICATIONS
14 SEER GAS ELECTRIC
PACKAGED UNIT
FORM NO. PRPGE14-100 (01/2021)
Page 1
REFRIGERANT SYSTEM
• Environmentally friendly R410A refrigerant
• Copper tubing with enhanced fin coils
• Internal service gauge ports
• Sleeved distributor tubes
• Antimicrobial insulated drain pan
• High and Low Threaded pressure switches for system protection
HEAT EXCHANGER
• GX models comply with California Energy Commission Low NOx
regulations
• Aluminized Tri-Dimple tubular heat exchanger for increased
efficiency
• Pest protected flue outlet
CABINET CONSTRUCTION
• Heavy-gauge galvanized steel base rails with rigging holes
• Rounded corners for safety and an attractive, clean appearance
• One piece base design for strength and stability
• Condensate and coil runoff drains to the perimeter of the unit
• Horizontal and downflow duct openings are flanged to minimize
water entry
• Low profile, with compact footprint
• Insulation to minimize heat loss plus reduce sound
• Textured pre-painted steel cabinet finish
• Superior service access to components
• Louvered coil guard protection
• One piece “no leak” top design
BLOWER
• Insulated compartment to reduce sound
• Efficient constant torque motor for wide airflow range
• Slide out blower housing for easy service
CONTROLS
• Solid state integrated blower control board with L.E.D. self
diagnostics
• Direct spark ignition
• Color coded wiring for easy service
INSTALLATION
• Horizontal or down discharge capable
• Horizontal and downflow duct covers provided with unit for
installation flexibility
• Drain pan float switch monitors condensate level in drain pan and
shuts down unit if drain becomes clogged
• Utility connections on “right side”
• Kits enable bottom gas and power entry through base pan
ACCESSORIES
• Clip roof curbs and adjustable pitch roof curbs available
• LP Gas Conversion
• Internal Filter kits
• Duct Adapters
• Closure kit for base rail openings
WARRANTY
10 year limited parts and compressor warranty/lifetime heat
exchanger warranty available. See limited warranty document
for details.
California Only
If installed in South Coast Air Quality Management District (SCAQMD) only: This
furnace does not meet the SCAQMD Rule 1111 NOx emission limit (14 ng/J), and thus is
subject to a mitigation fee of up to $450. This furnace is not eligible for the Clean Air
Furnace Rebate Program: www.CleanAirFurnaceRebate.com.
If installed in San Joaquin Valley Air Pollution Control District (SJVAPCD) only: This
furnace does not meet the SJVAPCD Rule 4905 NOx emission limit (14 ng/J), and thus
is subject to a mitigation fee of up to $450.

Summary of content (10 pages)