Owners manual

MWS- 808
7
too much from right to left. Next tighten the lock nuts. Make sure not to
tighten or loosen the centering bolt on this step by using another wrench to
ensure it doesn’t spin.
PROCESSING WIRE
Ø There is a wire guide in front of the main shaft and blade shaft where the cables will
be manually inserted. See wire input guide diagram below for a general
understanding of what wires can go in certain cutting channels.
Ø The wire input guide will be used as a general starting point for processing wire.
Before processing, it is recommended to collect similar wire types to assist in wire
processing efficiency.
Ø Selecting the correct input to run the wire through can take some time and
experience. The general rule is to start in a much larger wire guide than the wire in
question, run the wire, check the wire. If not cut, step down to a smaller input guide
and try it again. It is a general misconception that the user should put a wire in the
hole that is the exact same size of the wire. This is rarely the case. After a while the
user will know from experience which guide is right for certain wire types.
WIRE TYPE GUIDE
Ø Sheathed flat cable: ≤ 0.55” (14mm) x 0.31” (8mm) WxH
Ø Twisted flat cable: ≤ 0.31” (8mm) x 0.23” (6mm) WxH
Ø Single-core cable: Dia. Φ0.07” (2mm) ～ Φ1” (25mm)
Round cable Sheathed flat cable Twisted flat cable Single-core cable