Owners manual
MWS- 808
8
WIRE GUIDE DIAGRAM
RUNNING WIRE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Securing the machine and installing the hand-wheel and crank.
Ø Have your wires ready to process, by separating them by type and cutting them into
3-4’ lengths.
Ø Select a wire to strip.
Ø Decide on which guide is the correct guide input.
Ø Run the wire through while turning the hand-crank until the wire is all the way
through. You can also partially run the wire through with the hand-crank and go to
the output of the machine and pull the wire through the remainder of the way.
o If the wire did not cut through the complete jacket, run it through again
through a smaller channel.
o If there are no smaller channels, tighten the T-bolt half/full turn closest to the
channel you’re attempting to use.
Ø Separate the wire from the jacket
o On smaller wire this will be done by pulling the wire out of the jacket.
o For larger wires with thicker jackets, if you are not able to pull the wire out of
the jacket, you may need to run the wire through again cutting into the
opposite side of the wire jacket.