Owners manual

MWS- 808
10
Maintenance
Ø Keep machine clean and free of debris.
Ø Grease internal gears with red grease or Molybdenum grease as needed.
Ø Spray antirust oil on blades and blade shaft as needed.
Ø Inspect blades occasionally to ensure they are sharp for optimal cutting.
Changing Blades
1. Remove upper cutter/roller tensioners and the springs below them.
2. Use 11/16” socket to remove top bolts, and the spacers below them.
3. Take the top guard off.
4. Take the cutter assembly out.
5. Use adjustable large puller to pull bearing housing off the cutter assembly.
6. Use puller to pull bearing from cutter assembly. Make sure to mark the bearings position on
the steel rod to assure the correct position upon reassembly.
Chapter
5