Owners manual

MWS- 808
5
MACHINE COMPONENTS
Ø The main components of the MWS-808 are the central cutting and rolling assemblies.
These are driven by human power using a hand-wheel and hand-crank. The safety
guards are situated on top of the assemblies as well as in front where the wire guide
is situated.
o The safety components must be not be removed except by a qualified
technician.
Ø This machine has one primary adjusting point. The main way is though the two T-
bolts. These are the black bolts on the top of the machine that have a locking wing
nut. These T-bolts are used to tighten or loosen the springs that control the upper
cutting assembly. Essentially these are used to cut deeper or shallower into wire
jackets. If you are not able to put a piece of wire in a channel (and have already tried
to run it through larger channels), it may be necessary to loosen the T-bolt
o It is not uncommon for users to over-tighten these T-bolts thinking they need
more spring tension, when in reality they just needed to strip down a cutting
channel.