Manualshelf

Owners manual

ManualsBrandsBLUEROCK Tools ManualsToolsCG-30 Motorized Track Torch Burner Straight Line Cutter and Beveling by BLUEROCK ® Tools
9101112131415161718
CG- 30 TRACK TORCH BURNER MACHINE
9
Ø Ensure the torch tip is in a raised position so it will not get damaged when lifting up the machine
or putting down the machine.
Ø If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the
item falling over.
Ø DO NOT carry the machine by the cord.
Ø DO NOT allow the cord or plug to drag along the floor when transporting.
RUNNING THE MACHINE FOR STRAIGHT LINE CUTS
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Consider your security and stability as well as the orientation of the machine in the work area.
o Consider the work surface material, condition, strength, density and rigidity. These
factors directly affect the tools use.
o Ensure the piece being cut will be stable after the cut has been made.
Ø Ensure the work surface and machine are free of debris, oil, etc.
Ø Set the start/stop lever in the stop position.
Ø Set up cutting tracks. Ensure they are straight.
o NOTE: It may be necessary to mechanically clamp or secure the tracks by some method
depending on the application.
Ø Place machine at the start of the cut ensuring the wheels of the machine are set in the V in the
cutting tracks.
o NOTE: Make certain the wheels are free and not in the lock position with the wheel
“wing-nut” slightly loose.
Ø Select appropriate size torch tips for the application. Install tip.
Ø Connect applicable gas lines.
o Make certain they are properly secured and there are no leaks. It is highly recommended
that leak testing be performed on the system prior to using the machine.
o Ensure the lines are long enough to complete the cut you are planning.
o ALWAYS use gas tank cylinders with properly outfitted regulators/flowmeters.
Ø Select the neutral position in the machine directional toggle switch.
Ø Securely fasten the plug into the machine and lock in using the plug screw.
Ø Plug the cord into the external power source.
Ø Ensure the torch holder is not too close to the side of the heat guard. It should be set at least
4”s away from the side of the heat guard.
Ø Adjust the side knobs to raise the torch tip to a suitable level for lighting.
Ø Light the torch flame (see section below on proper lighting of torch flame).
Ø Adjust the side knobs a suitable level for cutting though the material.