Owners manual

CG- 30 TRACK TORCH BURNER MACHINE
10
Ø Select the drive direction using the toggle switch.
Ø Select the proper speed of the cut using the variable speed switch.
Ø Activate the machine start/stop lever to the start position to engage the machine directionally.
Ø When the cut is complete, stop the machine using the start/stop lever.
Ø Shut off the torch flame.
USING THE CIRCLE CUTTING ATTACHMENT
Ø Map out the circle on the surface of the steel.
Ø Drill a hole or use a punch to mark the center of the circle.
Ø Install the radius bar on the side main machine body.
o If the radius is small, the bar should be placed on the same side of the torch.
o If the radius is large, the bar and spike should be placed on the opposite side of the
torch.
o Put into the fixed holes and adjust the position of the fixing bar accordingly.
o Fasten the nuts to tighten the radius bar.
Ø Install the radius bar spike on the end of the radius bar.
o Tighten the spike.
Ø Loosen the wing-nut on the wheel so the back wheels can swivel.
Ø Use the procedure above to start the machine and make the cut.