Owners manual

MWS- 808PMO

just need enough room for the centering bolts to allow the entire assembly to

raise when a piece of wire goes through the channel and pushes up the entire

cutter assembly. It is generally recommended to set the centering bolts by

unscrewing the centering bolts on both sides of the assembly a few

turns. Then looking down the left (small wire) cutting channels, tap the

housing right or left to get the blades in the center of the channel. Screw the

bolts in evenly from both sides (right and left bolts). Be careful here not to

move the entire assembly. When they are tight against the housings, take

another look down the left channel guides making sure the cutters are still in

the center of the channel groove. If they are not, readjust. Next loosen the

centering bolts by about ½ a turn on both the right and left side. This leaves

just enough of an air gap to allow the cutting assembly to raise, but not travel

too much from right to left. Next tighten the lock nuts. Make sure not to

tighten or loosen the centering bolt on this step by using another wrench to

ensure it doesn’t spin.

PROCESSING WIRE

Ø There is a wire guide in front of the main shaft and blade shaft where the cables will

be manually inserted. See wire input guide diagram below for a general

understanding of what wires can go in certain cutting channels.

Ø The wire input guide will be used as a general starting point for processing wire.

Before processing, it is recommended to collect similar wire types to assist in wire

processing efficiency.

Ø Selecting the correct input to run the wire through can take some time and

experience. The general rule is to start in a much larger wire guides than the wire in

question, run the wire, check the wire. If not cut, step down to a smaller input guide

and try it again. It is a general misconception that the user should put a wire in the

hole that is the exact same size of the wire. This is rarely the case. After a while the

user will know from experience which guide is right for certain wire types.

WIRE TYPE GUIDE

Ø Sheathed flat cable: ≤ 0.55” (14mm) x 0.31” (8mm) WxH

Ø Twisted flat cable: ≤ 0.31” (8mm) x 0.23” (6mm) WxH

Ø Single-core cable: Dia. Φ0.07” (2mm) ～ Φ1” (25mm)