Owners manual

TYP- 75 MAG DRILL
11
Ø Insert the annular cutter into the ¾” adapter.
Ø Align the two “flat” sides of the annular cutter with the flat sides of the adapter.
o CAUTION: Make certain the hex screw is seated into the flat side and not
simply on the round side of the cutter shank.
Ø Tighten one of the hex screws while slowly rotating the cutter forward and
backwards.
o Continue to tighten the screw until fully tightened.
Ø Tighten the 2
nd
hex screw.
Ø The annular cutter is ready to use.
1) ¾” Adapter Hex Set Screws (2 total)
2) 1-1/4” Weldon Shank Set Screws (2 Total)
3) Annular Cutter (not included)