Owners manual

S 75 PIPE DRAIN CLEANER
10
o With gloved hand, pull the cable out or hold cable against the edge of the sewer inlet pipe until a
half circle is formed in the cable.
§ This essentially threads the cable out of the pipe.
o Release clutch.
o Push excess cable back through the machine from front to back.
§ Remember to turn off machine and disconnect sections as they come out.
§ When a section of cable is removed, insert the cable back into the cable carrier. Make
sure to reconnect the sections of cable to the last section of cable in the carrier.
o Repeat this operation until cable is fully out.
o Turn off machine. Disconnect Power. Remove safety hose.
o After using this machine, clean and flush cables, couplings and cutters with water.