Manualshelf

Owners manual

ManualsBrandsBLUEROCK Tools ManualsSpecialty Tool SetsS75 3/4" - 4" Sectional Pipe Drain Cleaning Machine Snake Cleaner by BLUEROCK ® Tools
78910111213141516
S 75 PIPE DRAIN CLEANER
12
General Maintenance
Note
SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.
DON’T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!
Ø Inspect electrical cords and electrical connections.
Ø Keep machine clean and free of debris.
Ø Flush cables with water after each use. Occasionally lubricate cables and couplings.
Ø Check for misalignment, binding and breakage of all moving parts. If damaged, repair tool before use.
Ø Check the cutters for sharpness or damage.
Ø Clean clutch teeth with wire brush. Check the attrition on the 3-jaw clutch. If the points are worn, replace with
identical piece.
Ø After each use coat all moving parts (including clutch driver) with corrosion resistant oil.
Occasional Maintenance
Ø Check brushes for wear and replace if worn.
Ø Grease main bearings thru grease fitting (see picture below).
Ø After a lot of use, clutch jaws may need to be replaced.
o Remove the screws that hold the front guard to the housing. Remove screws that hold the nosepiece on.
o Slide out clutch driver and replace jaws.
o Put nosepiece assembly and guards back on.
§ WARNING: DO NOT operate machine with guards removed.