Owners manual

S 75 PIPE DRAIN CLEANER
4
Operations
Note
THOROUGHLY READ THROUGH THE ENTIRE MANUAL BEFORE OPERATING THIS MACHINE!
PURPOSE
Ø The purpose of the S75 is for cleaning the insides of drainpipes from 3/4” to 4” in diameter. This is a
heavy-duty professional use machine allowing a single user to easily clean pipes.
Ø This type of sectional drain cleaner uses individually lengths (sections) of cleaning cable. This machine
uses 8’ sections, which can be added or subtracted during cleaning operations.
o Maximum length of any particular run should be 130’ (30M).
MACHINE SET-UP
Ø The machine is designed pre-assembled. The user must only take the item out of the shipping box.
o DO NOT allow the cord or plug to drag along the floor when wheeling between locations.
Ø Make certain the work area is dry.
o DO NOT place the machine in water.
Ø Use barriers to keep non-essential personal away from rotating drain cable or other moving parts.
Ø Place machine away from passageways and make certain the operator is able to see all parts of the work-
piece.
Ø DO NOT set-up or modify the machine in a manner that is not intended.
MACHINE COMPONENTS
Ø The main components of the S75 are the motor housing, rotating clutch channel and main machine frame
assembly (see figure below). The motor drives the clutch rotationally and acts as the main drive
component of the machine.
o These components must be not be removed except by a qualified technician. Power must be
disconnected prior to any service.
Ø The machine has a main on/off switch with a forward and reverse position. These switches operate the
turning mechanism, which turn the machine clutch. When the motor switch is turned on, the user is able
to pull clutch handle, which starts the clutch rotation. When the handle is released the rotation
immediately stops.
Chapter
3