Owners manual

WS- 260 WIRE STRIPPING MACHINE
10
Ø Have your wires ready to process, by separating them by type and cutting them into
3-4’ lengths.
o This is primarily for safety, but also to protect the motor from torque created
by pulling heavy wires into the machine.
Ø Go through the on/off functions to make sure they are operating correctly. Start the
machine by pressing the green “on” switch. Stop the machine by pressing the red
“off” switch.
Ø Turn the machine on.
Ø Select a wire to strip.
Ø Decide on which guide is the correct guide input if using the left multi-blade side or
adjust the handwheel (up/down) if running larger wire through the right single-blade
side.
o If using the single-blade side, ensure the blade is higher than the wire running
through. It’s always better to lower the blade on the next pass rather than the
blade cutting too deep into the wire or jamming up which can overload the
machine.
Ø Run the wire through.
o FOR THE LEFT SIDE; If the wire did not cut through the complete jacket, run it
through again through a smaller channel. If there are no smaller channels,
tighten the T-bolt half/full turn closest to the channel you’re attempting to use.
o FOR THE RIGHT SINGLE-BLADE SIDE; If the wire did not cut, lower the
cutting blade slightly and try again.
Ø Turn machine off.
Ø Separate the wire from the jacket
o On smaller wire this will be done by pulling the wire out of the jacket.
o For larger wires with thicker jackets, if you are not able to pull the wire out of
the jacket, you may need to run the wire through again cutting into the
opposite side of the wire jacket.