Owners Manual

INSTALLATION INSTRUCTIONS
Figure E: Remove
Mounting Screws
Remove Philips screws in
front and back of liner that
attach it to the outer shell.
Screws are located behind
scalloped detail in trough
front and back.
E. F.
Step 3: Set liner aside and prepare for blower installation.
1. If a duct cover is being used review pages 13-15 to determine which installation process will work best for your
application. If no duct cover is being used proceed to Step 4.
2. If installing an in-hood blower kit, proceed with Steps 4-1 (600 cfm single), or Step 4-2 (1200 cfm double).
3. If installing a remote blower kit, prepare the liner as follows:
Step 2: Remove ventilation hood liner from outer shell. (Figures A through F) – save all components and fasteners as
they will be used to reinstall the liner after the hood shell is mounted to the wall.
Figure A:
Remove Baffle Filters
Pull filter(s) towards front
of hood and tilt rear of
filter down to remove.
Figure B:
Remove Grease Trough
Turn wing fastener(s) ¼
turn to unlock.
Figure C:
Remove Inner Shield
Remove Philips screws (front
and back) attaching shield to
ventilation hood liner.
(Inner shield not on all models)
Figure D:
Remove Control Panel
Remove screws attaching
panel to ventilation hood
liner. Disconnect control
and light harnesses.
A. B. C. D.
8
Confirm discharge direction is correct for application.
If not, remove top/rear plate assembly and rotate as
needed. Reinstall fasteners. If in-hood blower
mounting plates are present, they should be removed
and discarded.
Step 1: Read all instructions thoroughly before beginning installation. If a duct cover is being used, please review
all steps before beginning – for some installations, the order of assembly may be altered. Details which are unique to
models starting with “MH” are shown on page 16.
Figure F: Remove
Liner from Shell
Carefully slide liner out
of outer shell.
Remove any protective
film from exterior of liner
and baffle filters.