manual
P/N 750323 Page 15
All specifications are subject to change without prior notification.
soapy solution. DO NOT USE AN
OPEN FLAME TO CHECK FOR
LEAKS. Such a procedure is dangerous
and it may not detect all the small leaks
that a soapy solution will.
16. Air shutter adjustments are preset at the
factory. These adjustments may need to
be redone and/or fine tuned by the in-
staller. These adjustments are normal.
They are the responsibility of the quali-
fied installer and are not covered by your
warranty.
17. A gas conversion performed in the field
may void your warranty. Contact your
dealer for information regarding the con-
version from one type of gas supply to
another.
INSTALLATION
ELECTRICAL CONNECTIONS
1. The installation of this appliance must
conform with all applicable local codes.
In the absence of local codes, the installa-
tion must conform to the latest level of the
National Electric Code, ANSI/NFPA 70.
2. This appliance is equipped with a standard
three prong polarized, NEMA 5-15P line
cord to be plugged into a 120Volt 15 Amp
outlet.
3. Removing the grounding prong from the
plug will void the manufacturer’s war-
ranty.
4. The cord exits the appliance at the lower
rear toward the left (viewed from front)
side.
5. If the electrical supply is not turned on or
is interrupted the appliance will not oper-
ate.
6. The applicable wiring diagram for this ap-
pliance is in the Quick Start Package.
7. The circuit where you plug your appliance
must be grounded and polarized.
8. We recommend the circuit for your appli-
ance be a non-GCFI dedicated line.
9. It is recommended that your circuit never
include a microwave oven.
WARNING!
This appliance is equipped with a three-
pronged grounding plug for your protec-
tion against shock hazard and should be
plugged directly into a properly grounded
receptacle. Do NOT cut or remove the
grounding prong from this plug.
If the appliance is not grounded or its po-
larity is reversed severe shock hazards
can exist.
IMPORTANT!
ALL GAS BURNERS NEED SUFFICIENT AIR
TO OPERATE AND LARGE OBJECTS
SHOULD NOT BE PLACED IN FRONT OF
THIS APPLIANCE WHICH WOULD OB-
STRUCT THE AIR FLOW THROUGH THE
FRONT.