manual

P/N 750323 Page 13
All specifications are subject to change without prior notification.
UNPACKING
1. Check the package for damage. If any
damage is visible you should mark the
bill of lading you sign that there may
be concealed damage.
2. Ensure the container is upright. If the
container is not upright major damage
can occur to your appliance. Thor-
oughly inspect your appliance for
damage. If damage is discovered, do
not refuse delivery. Contact the dealer
and file appropriate freight claims.
Save all packaging material. Do not
contact the manufacturer. Your appli-
ance was shipped from the dealer you
purchased it from. Shipping damage
claims are to be resolved between the
customer, shipping carrier and dealer.
The manufacturer may assist in resolv-
ing any such claims, but such assis-
tance does not relieve you of your re-
sponsibility.
3. Move the container as close to its in-
stallation location as possible. This
will reduce moving and handling your
appliance once it is out of its shipping
container.
4. Cut the straps holding the carton to the
palette. Lift the box directly up and
off the appliance. Do not use a ham-
mer. Do not cut the carton with a ra-
zor, utility or box cutting knife.
5. Remove and unpack any accessories
shipped with your appliance. Make
sure no hardware or accessories are
left to be disposed of unintentionally.
INSTALLATION
CAUTION!
 Each gas appliance shall be located
with respect to building construction
and other equipment to permit access
to the appliance. Such access and
clearance is necessary for cleaning and
servicing.
 Due to its size and weight, a rolling lift
jack, air sled or pallet jack should be
used to move the appliance into posi-
tion.
 Do not push against the edges or sides
of any appliance in an attempt to slide
it into position. Although all metal
parts are deburred during the manufac-
turing process, serious injury could
occur if the appliance were to move
suddenly while being positioned. We
recommend you use gloves during the
installation process.
 Do not use the louvered kick panel or
oven door handle to push or pull the
appliance into position.
 For optimum performance the appli-
ance should be leveled during installa-
tion. A carpenter type level should be
placed on the unit three ways: side to
side; front to back; diagonally.