INSTALLATION AND USER INSTRUCTIONS FOR THE GAS RANGE TOP FOR THE HOME THIS APPLIANCE WAS DESIGNED FOR EASE OF INSTALLATION AND OPERATION. HOWEVER, WE RECOMMEND THAT YOU READ ALL SECTIONS OF THIS MANUAL BEFORE YOU BEGIN INSTALLATION. INSTALLATION IS TO BE PERFORMED BY AN APPROVED GAS INSTALLATION OR GAS SERVICE TECHNICIAN. IN THE COMMONWEALTH OF MASSECHUSETTS A LICENSED PLUMBER OR GAS FITTER CAPABLE OF REVIEWING AND PERFORMING THE MANUFACTURER’S INSTALLATION CHECKLIST SHOULD INSTALL THIS APPLIANCE.
Since 1880, we have been dedicated to quality! We believe that our success can only be measured by the continuing success of our customers. We achieve customer satisfaction by ensuring that each of our employees understands, meets and exceeds customer expectations. We establish and maintain an environment that encourages all employees to pursue continuous improvement in quality and productivity. Our quality policy is monitored by the highest levels of management.
WELCOME ...to the exciting world of BlueStar™ cooking! You have purchased one of the finest appliances available for home use, which shows that you take cooking seriously. As the owner of a new BlueStar appliance you can look forward to years of cooking enjoyment.
TABLE OF CONTENTS Introduction ............................................................................................................................................ 2 Welcome................................................................................................................................................. 3 Table of Contents ................................................................................................................................... 4 Safety Instructions ...........
SAFETY INSTRUCTIONS To avoid personal injury or property damage, please read and follow these important safety precautions. 1. Before any maintenance or repairs are performed, disconnect the appliance from the electric supply. 2. Your appliance should be installed by a qualified gas installation technician. Have the technician show you the exact location of the gas shutoff valve on the incoming gas line so you know how to turn off the gas if necessary. 3.
SITE PREPARATION This appliance has been designed to be installed directly against rear walls and side base cabinets. It cannot be installed directly against tall side cabinets, side walls, tall appliances or base cabinets extending beyond 24 inches [610 mm]. Side trims must be at least 11/16 inch [17.5 mm] above the adjoining counter top surfaces. Any openings in the back wall or the floor of the installation site must be sealed.
RGTNB24 RANGE TOP SITE PREPARATION RGTNB 2011-REV1
RGTNB24 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB24 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB30 SITE PREPARATION RGTNB 2011-REV1
RGTNB30 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB30 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB364BSS SITE PREPARATION RGTNB 2011-REV1
RGTNB364 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB364 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB488BSS SITE PREPARATION RGTNB 2011-REV1
RGTNB48 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB48 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB6010BSS SITE PREPARATION RGTNB 2011-REV1
RGTNB60 RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB60 RANGE TOP RGTNB 2011-REV1
RGTNB364GHC SITE PREPARATION RGTNB 2011-REV1
RGTNB364GHC RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB364GHC RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB486GHC SITE PREPARATION RGTNB 2011-REV1
RGTNB486GHC RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB486GHC RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB606GHC SITE PREPARATION RGTNB 2011-REV1
RGTNB606GHC RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
RGTNB606GHC RANGE TOP SPECIFICATIONS RGTNB 2011-REV1
INSTALLATION UNPACKING 1. Check the package for damage. If any damage is visible you should mark the bill of lading you sign that there may be concealed damage. 2. Insure the container is upright. If the container is not upright major damage can occur to your appliance. If damage is discovered, do not refuse delivery. Contact the dealer and file appropriate freight claims. Save all packaging material. Do not contact the manufacturer. Your appliance was shipped from the dealer you purchased it from.
INSTALLATION BACKGUARD All range tops require a backguard. Most models have the option of using: an island trim; 7 inch standard; 17 inch hi-back; 21 inch high shelf. Heritage Classic models require a 21 inch high shelf for all installations. If you are using an island trim a six inch clearance between the back of the range and a combustible surface is required.
INSTALLATION GAS CONNECTIONS 1. The installation of this appliance must conform with all applicable local codes. In the absence of local codes, the installation must conform to the latest level of the National Fuel Gas Code, ANSI Z223.1/ NFPA 54. In Canada, the installation must be in accordance with the current CAN/CGA B149.1 and B149.2. 2. This appliance can be configured to work with either natural gas or LP gas. Verify that the appliance and the incoming gas supply are compatible.
INSTALLATION factory. These adjustments may need to be redone and/or fine tuned by the installer. These adjustments are normal. They are the responsibility of the qualified installer and are not covered by your warranty. 16. A gas conversion performed in the field may void your warranty. Contact your dealer for information regarding the conversion from one type of gas supply to another.
OPERATION BEFORE YOU TURN IT ON…. As part of the installation protective plastic wrappers on stainless steel surfaces should be removed. These wrappers must be removed before operation. New appliances are wiped clean with various cleaners and solvents to remove visible signs of dirt, oil and grease before leaving the factory. After installation, performance checks and adjustments, the appliance should be allowed to heat to burn off any such oils from internal parts.
OPERATION griddle plates and should be expected. After approximately 30 minutes, wipe away the oil and apply a second coat. Wipe away the excess. Increase the heat setting at the control knob 1/8 turn every 15 minutes. Stop at three quarters of the available knob rotation. Do NOT heat to the maximum setting during the seasoning process. During normal use if the griddle is not overheated or food is not allowed to stick re-seasoning should not be required.
OPERATION “click”. As gas flows through the piping to the burner the sparking ignites it. After the flame lights the igniter senses its heat and the clicking automatically stops. After a short while as the French Top heats it will begin to discolor. This is a normal characteristic of steel plates and should be expected. The coloring will be varying shades of blue to black. It is permanent and to be expected. Always pre-heat your French Top at least 10 minutes before cooking.
CLEANING BODY All stainless steel and painted parts should be cleaned regularly with hot soapy water. Commercially available stainless steel cleaners may be used on stainless steel. Be sure to follow manufacturer’s instruction for use. Do NOT use steel wool or metal pads or other abrasive cleaners. These surfaces are painted or polished and using these products will scratch and damage your finish.
CLEANING Always allow the char broiler to cool before trying to clean it. Remove the drip pan by pulling straight toward you - SLOWLY. Beware to avoid spilling the pan. Clean with hot soapy water. The grease tube may be cleaned with hot soapy water and a bottle brush. Clean the drip pan and grease tube thoroughly after each use to avoid a fire hazard. The char broiler grates are porcelain coated or chrome plated. They may be cleaned with hot soapy water.
HELPFUL HINTS TOP BURNERS Insure the top grates are properly positioned so your cooking pan will sit flat and level. A front top grate may be removed and the cooking pan placed directly into the cutout for stir-fry cooking.
CARE AND MAINTENANCE AIR SHUTTER ADJUSTMENTS Air shutter adjustments are preset at the factory. These adjustments may need to be redone and/or fine tuned by the installer. These adjustments are normal. They are the responsibility of the qualified installer and are not covered by your warranty.
TROUBLESHOOTING PROBLEM SOLUTION Burner won’t light—no “clicking” from igniter Ensure appliance is plugged in. Ensure circuit is not tripped or fuse blown. Burner won’t light—”clicking”, no flame Ensure gas is turned on. Ensure burner ports are clean. Try a second burner for same or different result. Ensure electrode is plugged in. Ensure electrode is properly lined up. Ensure electrode is not cracked—spark not in correct place. Ensure venture tube is properly on orifice after cleaning.
WARRANTY WHAT IS COVERED? Prizer-Painter provides the following limited warranties to the original retail purchasers of Products sold and installed in the continental United States and Canada on or after February 22, 2002: Prizer-Painter warrants that all cosmetic components of its Products will, Initial Seven (7) Day Limited Warranty.
WARRANTY WHAT IS NOT COVERED? This Limited Warranty is the sole and exclusive warranty provided for the Product and extends only to original retail purchasers in the continental United States and Canada. This Limited Warranty is not transferable to any subsequent purchasers or users.
PERFORMANCE CHECKLIST This checklist has been developed to assure proper installation of your appliance To validate your warranty you must mail or fax this form and a copy of your receipt to: Warranty Department, Prizer-Painter, 600 Arlington Street, Reading, PA 19611, Fax (610) 376-2596 Customer Information (Please Print) Product Information (Please Print) Name:________________________________________ Model No: ________________________________ Address: ______________________________________ Serial No: __
PERFORMANCE CHECKLIST This checklist has been developed to assure proper installation of your appliance To validate your warranty you must mail or fax this form and a copy of your receipt to: Warranty Department, Prizer-Painter, 600 Arlington Street, Reading, PA 19611, Fax (610) 376-2596 Customer Information (Please Print) Product Information (Please Print) Name:________________________________________ Model No: ________________________________ Address: ______________________________________ Serial No: __
