Owners Manual

BURNER SETTINGS

 Burners can be set to any setting between SIMMER and HIGH.

 The flame should be adjusted to not wrap around the bottom edge of any pot or pan using the knob.

If the flame is set too high in relation to the edge of the pot or pan, you might scorch the backguard or

other areas around your range

Do not leave empty non-stick pans on the French Top as the heat may damage the coating and the

French Top surface.

 At the HIGH setting, flames should appear as a defined cone with a dark blue center and light blue outside. Some

yellow/orange flame may be seen depending on the type of gas and the supply line.

RING GRATES AND TOP GRATES

TIP: When placing the top grate back on the burner support, locate the sides with the raised edges and ensure they are

positioned to the left/right side of the burner. Insert the ring grate into the top grate by aligning the small notch in the top

grate with the small indents in the ring grate.

If the top grate is unsteady, remove both the top & ring grates, and adjust the four screws in the corners underneath the

top grate accordingly to even out the top grate.

Simmer Burner

The SIMMER burner gives you a choice of simmer settings from SIMMER to HIGH. The SIMMER setting can be used to

gently melt chocolate and hold delicate sauces at low temperatures.

 For the lowest simmer setting, push in and turn the knob to HIGH to ignite the burner, then turn counter clockwise to

the SIMMER setting on the knob.

o For burners without the SIMMER setting marked on the control knob, push in and turn the control knob to

HIGH to initially ignite the burner, then turn the knob counterclockwise past the LOW indicator until the knob

stops.

 For best simmer results only use the simmer burner. To locate the simmer burner on your range, reference the

burner configuration in the beginning of this manual. The simmer burner is located in the back left position of most

ranges.

Your ring grates, top grates and burner heads may darken over time with use. This is normal.

TIP: To prevent your burners from darkening at an uneven rate, rotate the ring grate and top grates between more and

less active burners.

BURNER CLEANING

Ring Grates and Top Grates

TIP: Clean spills as soon as possible to prevent sticking and build up.

 When burner is cool, remove the ring grate, top grate and center filler grate (30” models only).

 Wash in hot, soapy water. Rinse well and dry thoroughly to prevent rusting.

 Handle gently to prevent nicks/chips, which can lead to rusting

TIP: If you have a nick or chip you can season the area to prevent rusting. Nicks or chips are not covered under warranty.

 Put corn oil or other high smoke point oil on a paper towel and rub onto rusted area.

 Wipe away excess oil and replace the part on the range.

ATTENTION