Use and Care & Installation Guide

INSTALLATION INSTRUCTIONS
Step 4-3. Installing Remote Blowers
11
ELECTRICAL CONNECTIONS
WARNING: TURN OFF POWER AT THE SERVICE
BOX PRIOR TO WIRING BLOWER
1. Power supply for the blower s 115V AC, 60 Hz. See
page 2 for specifications
2. Run electrical cable between the blower and the
range hood or blower and wall switch. See Figure 3
3. Remove top enclosure of the blower for access to
the wiring terminal block.
4. Push the electrical cable up through the bottom
knock out of the blower body. Pull enough wire up
into the housing to make attachment to the terminal
block.
5. Connect white, black and green wire to three
terminal block on hood.
DUCT CONNECTIONS
1. Use only round metal duct, elbows and transitions;
or rectangular ducting having equivalent area of
square inches as per required duct size.
2. Tape or use joint sealant on all joints.
3. Turn on power and check blower operation.
4. Make sure damper opens and closes freely.
Figure 3