Use and Care & Installation Guide

INSTALLATION INSTRUCTIONS
Step 4-4. Installing In-line Blowers
12
Mounting Option 1:
Please follow all applicable codes when installing this unit
1. Equipment should be hung at its proper elevation by
using temporary fixtures that can be removed after
vibration hangers are installed.
2. Hanger may be fastened directly to the structure or
somewhere between suspended unit (be sure not to
over tighten the neoprene element.
3. Install hangers.
4. Turn nuts on rod assembly clockwise one complete turn
on each hanger. Repeat this procedure until temporary
hanging fixtures are loose and load of piping or
equipment is suspended completely on the vibration
hangers.
5. Remove temporary hanger fixtures and level piping or
equipment by taking additional turns on the spring/top
hanger rod nut – clockwise to raise, counterclockwise to
lower as required.
6. If equipping fan with isolators, they should be attached
at this time.
7. See wiring section to complete installation.
Mounting Option 2:
Please follow all applicable codes when installing this unit.
1. Install wood supports to structure for fan mounting.
2. If equipping with vibration mounts, attach to supports.
3. Attach fan to vibration mounts (be sure not to
overtighten the neoprene element).
4. If equipping fan with isolators, they should be attached
at this time.
5. See wiring section to complete installation.
Mounting Option 3:
Please follow all applicable codes when installing this unit.
1. Create/install angle wood supports to structure for fan
mounting.
2. If equipping with vibration mounts, attach to supports.
3. Attach fan to vibration mounts (be sure not to
overtighten the neoprene element).
4. If equipping fan with isolators, they should be attached
at this time.
5. See wiring section to complete installation.