Instructions / Assembly

ManualsBrandsBluestone ManualsOtherDigital Blood Pressure Wrist Cuff

Unit Operation Unit Operation

Unit Operation

2423

25 26

Memory Deletion

Memory for a selected group may be deleted while in Memory

Check mode. Press and hold the " SET " button for

approximately 3 seconds to delete all memory records from the

selected group. The monitor will beep indicating successful

deletion and then transfer into testing mode. To delete momories

from other groups, please refer to " Select Memory Group " on

page 10. Then press the " START/STOP " button to turn the unit

off.

Note: Memory cannot be recovered once it has been deleted.

Low Battery Indicator

4 short warning beeps sound when battery life is depleting and

unable to inflate cuff for testing. The " " appears

simultaneously for approximately 5 seconds prior to shutting

down. No memory loss will occur

throughout this process.

Replace batteries at this time.

Unit Operation

Safety Precaution: If pressure in cuff becomes too extreme

while testing, press the " START/STOP " button to turn

power off.

The cuff pressure will rapidly dissipate once the unit is off.

User may delete their current test result due to unfavorable

testing conditions or for any other reason. To delete the last

test result, press the "SET" button after result is displayed.

If result is not deleted, it will automatically store by date

within the previously configured Memory Group.

Deleting/Storing Test Results

Note: Be sure the appropriate Memory Group selection is

made prior to testing.

Power Off

The " START/STOP " button can be pressed to turn off the unit

in any mode.

The unit can turn off the power itself about 3 minutes no

operation in any mode.

If the number of tests surpasses the allotted 60 memories per

group, the most recent tests will appear first, thus eliminating

older readings.

With power off, press the " M " button to activate

screen display. After the unit performs a self diagnosis, the

screen will display the average test results from the last 3

readings of the last group used . The " " symbol will appear

along with the corresponding WHO Blood Pressure Indicator.

To check the average results from other groups, select the

desired group first prior to activating the " M " button

in the off position (See "Select Memory Group" on page 13).

Press the "M" button again, you may check past test results.Upon

activating test results, you can press the"M "button to scroll through

all test results stored in memory. The LCD will display the last

memory as NO: 01 reading.

Note: Past test results will only be displayed from the most recently

used memory group. To check past test results in other memory

groups, you must first select the desired group and then turn

monitor off . ( See Select Memory Group on Page 13. )

Memory Check and Last 3 Tests Average

mmHg

AVG

mmHg