Instructions / Assembly

ManualsBrandsBluestone ManualsBlood Pressure MonitorsDigital Blood Pressure Upper Arm Cuff

Unit Operation

Troubleshooting

Problem

Solution

" "displayed

Cuff is too tight or not

properly positioned on

the arm

Firmly reposition cuff

approximately ( )

above the elbow joint

( See Page 12)

1-2cm 1/2"

Inaccurate test results due to

body movement or monitor

movement

Sit in a relaxed position with

arm placed near heart. Avoid

speaking or moving body parts

while testing. Make sure the

monitor unit is placed in a

stationary position throughout

the testing period.

( See Page 7)

Blood pressure

results are not

within typical range

Cuff fails to inflate properly

Make sure hose is properly

fastened to cuff and monitor unit

Possible Cause

Pressurization is over

300mmHg

Read user manual carefully and

re-test properly.

Improper operation

Read user manual carefully and

re-test properly.

Unit Operation

Low Battery Indicator

4 short warning beeps sound when battery life is depleting and unable to inflate cuff for

testing. The " " appears simultaneously for approximately 5 seconds prior to shutting

off. No memory loss will occur throughout this process.Replace batteries at this time.

Unit Operation

Memory Deletion

Memory for a selected group may be deleted while in Memory Check mode. Press and hold

the " SET " button for approximately 3 seconds to delete all memory records from the

selected group. The monitor will beep indicating successful deletion and then transfer into

testing mode. Press the "START/STOP " button to turn the unit off.

Note: Memory cannot be recovered once it has been deleted.

Memory Check

Unit Operation

With power off，you may check past test results by using the "M" button. The

most recent test result and oldest test result in memory can be viewed by pressing

and holding the "M" button. Upon activating test results. you can press the "M"

button to scroll through all test results stored in memory.

Note：Previous test will only be displayed from the most recently used memory

group . To check previous test results in other memory groups, you must first

select the desired group and then turn monitor off.(See"Select Memory Group" on Page 10 )

mmHg