Product Literature

© 2019 Blum, Inc. Subject to technical modifications without notice
16
Hinges
Maximum door overlay
Trial application recommended
Maximum door thickness
Trial application recommended
NOTE: For thick door applications, you must bore at the specified
boring distance listed in the chart below
Mitered door with large overlay
Trial application recommended
Thin facing added to door
Trial application recommended
H Overlay
0 19 22 24 26 28 30 32 34
8 11 13 15 17 19 21 23
B = boring distance
Minimum reveal T = door thickness
2 28 27 26 25
3 4 5 6 7
8
B = boring distance
*Minimum reveal is 1 mm on a 25 mm thick door when bored at 8 mm
Straight-arm Soft close
Screw-on
*
▀ 71B7550
Press-in
*
▀ 71B7580
INSERTA
*
▀ 71B7590
54.6
1.5
19
19
5.1
B = 25.1
1.3
1
11
37
H = 0
1
19
11.7
2.9
110°
B
1.5
11.7
110
°
37
reveal
T
H = 0
1.5
11
37
19
34 max
H = 0
11.7
B = 23 max
110
°
16
16
4
20
B = 5
37
1.5
31 max
H = 0
11.7
110°
CLIP top BLUMOTION 155°
Straight-Arm Special Applications
70T7553
70T7553
70T7553
70T7553
Abbreviations
H = Plate height
P = Door protrusion
S = Side arm protrusion
W = Side panel width
NOTE: Inset application can also be achieved with either a straight-arm hinge with a 18 mm plate or half-cranked hinge with 9 mm plate.
Setback of mounting plate would be 38.5 mm + door thickness.
NOTE: Special applications can be achieved in face frame cabinets by blocking out behind the frame or use of the new CLIP wing plates (pages 62-63)
155°
Angle restriction clips
NOTE: For use with 155°/125° zero
protrusion hinges.
70T7553.0970T7553
Part no. Part no.
110° restriction clip 92° restriction clip
▀ Gray nylon ▀ Gray nylon