Installation Manual

Subject to technical modifications without notice.
Dimensions in millimeters (inch equivalents as noted) © 2013 Blum, Inc.
2
Preparing for hardware installation
NOTE: Use of the T65.1600 template is essential for accurate location and angle of pre-bored
locking device holes and accurate boring for rear hook holes
Drawer specifications
Face frame and panel cabinet applications
Front view
NOTE: Because material thickness may vary, the inside drawer width must equal opening
width minus 42 for TANDEM to align and function properly
6 (1/4")
minimum top
clearance
opening width
opening height
13 (1/2")
drawer side thickness
maximum 16 (5/8")
14 (9/16")
bottom clearance
37
(1-15/32")
21 (13/16")
drawer height maximum =
opening minus 20 (25/32")
inside drawer width = opening width minus 42
#6 head
wood or
system
screws
6 mm bit with
stop collar
2.5 mm bit with
extension chuck
pre-boring holes for
locking devices
pre-boring holes
for rear hooks
75
°
Installation screw
606N or 606P
Template
T65.1600
T51.1801
T51.1901
Locking device
with side adjustment or
without side adjustment
Drawer insertion
Extend the drawer runners fully. Place the drawer on the runners and close.
The locking devices automatically engage with the runners.
Make adjustments if necessary.
Drawer removal
Squeeze orange handles on locking devices
Pull drawer straight out and up
1
2
1
2