Manual

DA44AU USER MANUAL
04
www.blustream.com.au | www.blustream.co.uk
1 Power Indicator LED - Illuminates when the unit is powered on
2 Input Indicator LED - Illuminates when an analogue audio signal is detected on the associated input into the unit
3 NET Indicator LED - Illuminates when the unit is receiving a Dante® network audio signal and audio is output
4 Link Indicator LED - Illuminates when the unit is connected to PC configuration soware
5 48V Phantom Power Indicator LED - Illuminates when 48V phantom power is enabled on the associated input
6 Output Indiciator LED - Illuminates when a Dante® audio signal is being received and output via the assosiated output
7 LCD Display - Shows the status of network connection and menu selection
8 ESC Button - Escapes out of selected menu option
9 Rotary Dial / Enter Button - Rotate dial to scroll through selected menu item, press to select current menu item
q Power button - Press to turn the unit on or o
Front Panel
1 2
4 6 7 8 9 103 5
1 Power Port – Use included 12V/1A DC adaptor to power the device
2 Dante® Network Ports - 2 x RJ45 sockets to connect to Dante® network, note the DA44AU will only allow 1 network connection at
a time, the device does not have two independent network interfaces. The 2nd RJ45 is for redundancy but can also be cascaded
to additional DA44AU units (up to 7 x devices)
3 RS-232 Port – 3-pin Phoenix connector to for control of the device from a computer or 3rd party control processor
4 4ch Audio Outputs - 12-pin Phoenix connector to connect to audio amplifier or mixing device, supports both balanced and
unbalanced audio output from devices connected to the Dante® network (Note: will not output audio connected to the input of
the same DA44AU device due to limitations of the Dante® Ultimo chipset)
5 4ch Audio Inputs - 12-pin Phoenix connector to connect to microphone or source audio device to convert the input signal to
Dante® audio, supports both balanced and unbalanced signals including 48V phantom power
Rear Panel
2 3 4 51