Manual

HEX11WP-TX QUICK REFERENCE GUIDE
www.blustream.com.au | www.blustream-us.com | www.blustream.co.uk
02
Front Panel Description
1 Power Status Indicator - Illuminates when powered
2 HDBaseT™ Link Status Indicator - Illuminates when the transmitter is connected to a HDBaseT™ receiver / matrix
product successfully
3 EDID Selection Button – Cycle through 2 EDID modes - see EDID Management below
4 IR Receiver - Built in IR sensor for IR pass-through
5 HDMI Input - Type A HDMI port to connect HDMI source
6 HDBaseT™ Output - RJ45 HDBaseT™ port to connect to the HDBaseT™ input port of the compatible Blustream
HDBaseT ™ receiver / matrix device
7 12V DC Input - 2-pin Phoenix connector to connect to Blustream 12V power supply (supplied)
8 IR Receiver Input - 3-pin Phoenix connector to connect to Blustream IR receiver (not supplied)
9 RS-232 - 3-pin Phoenix connector for RS-232 pass-through to / from compatible Blustream HDBaseT™ device
Note: When powering the HEX11WP-TX locally and using PoC to power a compatible Blustream receiver device, power
is only enabled when an active HDMI source device is connected to the HEX11WP-TX. This feature is used to trigger auto
switching on the Blustream SW41HDBT HDBaseT™ Switcher.
Products from Revision B onward.
2
4 5
7 8 96
Rear Panel Description
The HEX11WP-TX features automatic EDID management to ensure signals being transmitted fall within the 10.2Gbps
bandwidth requirement of HDBaseT™. The HEX11WP-TX will evaluate the EDID of the display device and modify its
EDID value to ensure compatibility. The default maximum resolution supported is 4K @60Hz 4:2:0. By pressing the
EDID selection button you can limit the maximum EDID to 4K @30Hz 4:4:4.
Note: Products from Revision B onward.
1
3
EDID Management