Manual

HEX31WP-TX USER MANUAL
06 www.blustream.com.au | www.blustream.co.uk
Auto Switching
The HEX31WP-TX can automatically switch sources based on when an input signal is detected or lost. This feature will
automatically switch to any new source that is connected to the HEX31WP-TX, and subsequently will switch back to the
previous source when a signal is lost.
To enable or disable this feature, press and hold the the Auto Switching button for 3 seconds. The Auto Switching
button LED will blink to confirm this command has been received.
The Auto Switching button will remain lit when auto switching is enabled.
USB Type C
The USB-C input of the HEX31WP-TX gives instant connectivity with laptops and smart devices with USB-C, negating
the requirement of having to use USB-C to HDMI adaptors to obtain AV connectivity.
Not all USB-C cables support the transfer of Video and Audio. A type 3.1 USB-C cable must be used to ensure AV can
be transferred over the USB-C cable. The cables supplied with laptops or mobile devices are normally reserved for
charging only and are generally not type 3.1.
The USB-C input of the HEX31WP-TX does not support charging of mobile devices.
Mounting the HEX31WP-TX
The HEX31WP-TX has been designed to fit into a standard UK or European double-gang backbox. The mounting holes
are hidden under the magnetic faceplate on the le / right (for UK backboxes), and top / bottom (for EU backboxes).
A minimum backbox depth of 40mm is required, however, due to the normal operating temperature of HDBaseT
equipment, we would recommend using a deeper backbox (47mm) to assist with additional heat displacement and air
circulation to the rear of the unit.
Prior consideration should be made to the choice of backbox, with particular emphasis to the location/s of cable entry
so that the maximum bend radius of the CAT cable is not exceeded.
If mounting the wallplate into a counter top, table top, or lecturn, a backbox may not necessarily be required. Please
see below technical drawing of the unit for overall and cut-out dimensions: