Manual

HEX31WP-TX USER MANUAL
08 www.blustream.com.au | www.blustream.co.uk
RS-232 Configuration
The RS-232 port is used for configuration / control of the product, including pass through of RS-232 commands to a
compatible Blustream HDBaseT™ Receiver / Matrix device.
The default RS-232 communication settings are:
Baud rate: 57600
Data bit: 8
Stop bit: 1
Parity bit: none
Common Mistakes
• Carriage return – Some programs do not require the carriage return where as other will not work unless sent directly
aer the string. In the case of some Terminal soware the token <CR> is used to execute a carriage return. Depending
on the program you are using this token maybe dierent. Some other examples that other control systems deploy
include \r or 0D (in hex)
• Spaces – Blustream commands do not require space between commands unless specified. There may be some
programs that require spacing in order to work.
- How the string should look is as follows OUT01FR02
- How the string may look if spaces are required: OUT{Space}01{Space}FR{Space}02
• Baud rate or other serial protocol settings not correct - please confirm the settings being used match the RS-232
configuration settings above.
RS-232 Commands
? Print Help Information
HELP Print Help Information
STATUS Print System Status And Port Status
INSTA Print All Input Status
OUTSTA Print All Output Status
CTRLSTA Print All Control Status
RESET Reset System To Default Setting
KEY ON/OFF Set System Key Control On Or O
OUT xx FR yy Set Output xx From Input yy
Input: yy [01-03]
01 = HDMI 1
02 = HDMI 2
03 = USB-C
OUT xx SWITCH yy Set Output xx Auto Switching To aa
aa = AUTO
aa = MAN
NOSIGDLY xxx Set No Signal Delay Timeout to xxx
IR ON/OFF Set System IR Control On Or O