Quick Start Guide

contact [e-mail] / [e-mail]
HSP14CS QUICK REFERENCE GUIDE
Front Panel
Panel Descriptions
1 Power button - press to power on / o the splitter
2 Power LED indicator - indicates if the unit is on or o
3 Input LED indicator - indicates if a source is attached and is active
4 HDMI output indicator - indicates if a HDMI output is attached and is active
5 HDBaseT™ output indicator - indicates if a HDBaseT™ receiver is attached and an active link is available on the output
6 Upgrade port
1 HDMI input - connect to a HDMI source
2 HDMI output - connect to a HDMI display or additional HDMI distribution equipment
3 HDBaseT™ outputs - connect to HDBaseT™ receivers
4 HDBaseT™ link lights
5 IR input - 3.5mm stereo jack. Transmits IR to the zone HDBaseT™ receivers (displays)
6 IR output - 3.5mm mono jack. Connect to Blustream 5V IR emitter for source control from remote areas
7 Coaxial audio out - RCA connector, de-embedded audio from the HDMI input
8 L/R audio out - 3.5mm stereo jack, de-embedded audio from the HDMI input. Source input must be PCM 2ch audio
for the analogue audio output to work. The HSP14CS does not down-mix 5.1ch audio signals.
9 EDID DIP switch - used for global EDID settings, see page 3
q Power port - use supplied Blustream 12V adaptor to power the splitter
1 2 3 4 5 6
1 2 3 5 6 7 8 9 104
Rear Panel
Upgrade
Output
HDMI
HDBT1 HDBT2 HDBT3 HDBT4InputPower
4-Way HDBaseT™ Splitter - Supporting 4K 60Hz 4:4:4 (40m)
Link Link Link Link
IR IN
0
0123
1
IR OUT
Coaxial
Audio Out
EDID DC 12V
L/R
Input Output
HDBT Output 4HDBT Output 3HDBT Output 2HDBT Output 1
HSP14CS
02