User Guide

48” WATERGARDEN WATER FEATURE
INSTRUCTIONS FOR USE
INSPECT FOR SHIPPING DAMAGE – ANY DAMAGE FROM SHIPPING SHOULD BE IMMEDIATELY
REPORTED TO THE DELIVERY AGENT. DO NOT ATTEMPT TO OPERATE IF UNIT IS DAMAGED.
48” WATERGARDEN INSTRUCTIONS
1. REMOVE WATERGARDEN FROM THE SHIPPING CONTAINER.
2. PLACE WATERGARDEN IN THE DESIRED LOCATION.
3. REMOVE ALL PACKING FROM THE RESERVOIR.
4. FILL THE RESERVOIR WITH WATER.
5. PLUG IN THE CORDS INTO A STANDARD OUTLET TO START WATER FLOWING AND
LIGHT.
6. ADJUST WATER FLOW IF NECESSARY BY TURNING VALVE IN RESERVOIR.
7. POSITION LIGHT AS DESIRED.
8. ENJOY!
What if water doesn’t flow?
In some cases, the pump may have an air bubble trapped inside. Try turning the unit off and on
a few times. If this doesn’t work, reach into the reservoir and tip the pump, while submerged,
to release any air. If necessary, this procedure will only have to be done upon the initial start
up.
THANK YOU FOR PURCHASING A BLUWORLD™ WATERFEATURE. OUR ARTISTIC
DESIGNS AND SUPERIOR WORKMANSHIP BRING WATERFEATURES DESIGNED FOR A
LONG-TERM DECORATIVE EFFECT, TO PRODUCE RELAXING SOUNDS AND TO
PROMOTE A HEALING ENVIRONMENT.
WE HOPE YOU WILL ENJOY YOUR DESIGNER WATERFEATURE.
SHOULD YOU EXPERIENCE ANY PROBLEMS, PLEASE DO NOT
RETURN TO RETAILER.
CALL 1-888-499-5433 AND ASK FOR CUSTOMER SERVICE FOR A QUICK SOLUTION TO
YOUR PROBLEM.
CARE AND MAINTENANCE
DO NOT ATTEMPT TO MOVE THE DISPLAY ONCE IT IS FILLED WITH WATER. EMPTY THE RESERVOIR BEFORE MOVING.
MAINTAIN THE WATER LEVEL BY FILLING TO 2” BELOW THE TOP EDGE OF THE BASIN ABOUT ONCE A WEEK.
WATERFALLS THAT ARE PLACED NEAR AIR CONDITIONING VENTS AND INTAKES WILL EVAPORATE AT A FASTER RATE.
DO NOT OPERATE IF LOW ON WATER. IF HARD WATER IS A PROBLEM IN YOUR AREA, THE USE OF DISTILLED WATER
WILL GUARANTEE THE BEST RESULTS. IT IS RECOMMENDED TO DRAIN THE RESERVOIR ABOUT ONCE EVERY THREE
MONTHS AND REFILL WITH CLEAN WATER. BE CAREFUL NOT TO GET CLEANING AGENTS INTO THE WATER. THE
SPRAY BAR, WHICH DISTRIBUTES WATER ONTO THE GLASS, MAY BE REMOVED FOR CLEANING.
Your Bellezza/Watergarden water feature is manufactured from composite materials similar to those used in the manufacture of
fiberglass watercraft. Each one is individually hand crafted and hand finished, and no two are exactly alike. Slight
imperfections are not to be considered flaws, but are designed to add to the individual character of each unit. They are
designed to emulate the appearance of natural stone.
LIMITED WARRANTY
Bluworld of Water warrants this product to be free from defects in material and workmanship for one (1) year from the original date of purchase by
the consumer. This warranty is limited to the replacement of defective parts or components. In addition, the submersible pump is warranted by its
manufacturer for a period of one (1) year against defective material and workmanship. All claims must be presented to the manufacturer along
with the original purchase receipt to verify a valid warranty period. Bluworld of Water will not be responsible or liable for any damage caused by
negligence or misuse, goods damaged in transit, or improper set up, installation or assembly by the purchaser. Bluworld will, upon written
notification thereof, take commercially reasonable steps to correct such defects, at Bluworld sole option, by suitable repair, replacement, or refund.
Please read all instructions carefully. Notice: Glass mirrors and plastics have prevalent characteristics such as bubbles, mirror rubs, slight
discolorations, blurs, and hairline scratches. These are to be expected, as they are inherent qualities that meet or exceed federal specifications
DD-G-451D.
BLUWORLD OF WATER
635 W Michigan St. Orlando, FL 32805
407-426-7674 f 407-426-7721 www.bluworldusa.com
©2004 Bluworld Innovations LLC, Inc. All Rights Reserved
M A D E I N C H I N A