Bellezza Instructions for Use 635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721 www.bluworldusa.com · http://shop.bluworldusa.
Water Feature Light (A) Pump (D) Photo may vary Light Transformer (B) 3 Wall Anchors (E) Plants (C) Splash Guard (F) Wall Bracket (G) Bellezza Assembly: Tools Required: Level Pencil Phillips Screwdriver Measuring Tape Decide where you would like to install your Water Feature. ** It is critical that your waterfall is level as this will ensure even water flow. ** a. Due to the relatively light weight nature of your new Water Feature, it is not necessary to mount it directly into wall studs. b.
1. Marking the Waterfall Location a. Locate your Level. b. Draw a line on the wall indicating the top of the waterfall. See Fig 1.A. Measure the distance between the top of your fountain and the center of the wall bracket. Use those measurements and on the wall, draw a line down from the line made in Fig 1.A to indicate your mounting location. See Fig 1.B. 1.A 1.B c. Using a level, hold the Wall Bracket (G) to the wall with the top angled towards you. Mark both mounting holes on the wall.
3. Installing and Operating your Water Feature a. Unwind the Pump and Valve (F) (Now to be referred to as “pump”) and Water Feature Light and Transformer (A&B) power cords and run them behind the half circular cut behind the reservoir as shown in Fig 3. A. 3.A b. Connect the Fountain Light (A) to the Transformer (B) as shown in Fig. 3.B. 3.B c. Lift your waterfall into place and engage the bracket on the back of the fountain by lowering it onto the Wall Bracket (F) as shown in Fig 3.C. 3.C d.
f. Fill the reservoir with water. We recommend filling the water up to the bottom of the mirror frame to minimize the risk of micro splashing. The water level must be maintained at least 1/2” above the pump. If the water level drops below the pump, damage to the pump may occur and void your warranty. g. After filling the reservoir with water, install Splash Guard (G) into grooves on each side of the frame below the disperser (grey pipe) as shown in fig 3.G – 3.H. 3.G 3.H h.
and if the product is used unreasonably, or for purposes other than as intended, or if it is altered, modified or repaired by a party other than Bluworld, then the Warranty shall be null and void. The Warranty is in effect for a period of six months beginning from the date of sale to the original retail purchaser and the rights under this Warranty are limited to the original retail purchaser.