Instructions / Assembly

f. Fill the reservoir with water. We recommend filling the water up to the bottom of
the mirror frame to minimize the risk of micro splashing. The water level must be
maintained at least 1/2” above the pump. If the water level drops below the pump,
damage to the pump may occur and void your warranty.
g. After filling the reservoir with water, install Splash Guard (G) into grooves on each
side of the frame below the disperser (grey pipe) as shown in fig 3.G – 3.H.
3.G 3.H
h. You can now plug the pump into the wall. As water begins to flow down the
surface, guide the water with your hand or use a non-abrasive sponge until the
water flows evenly over the entire waterfall surface. It may take a few minutes for
the water to cover the entire waterfall surface.
i. Install plants into pipettes as shown in Figures 3.I-3.J.
3.I 3.J
Please refer to supplementary Maintenance Guide for further information as to how to keep your
water feature clean and looking beautiful for many years
Warranty
Bluworld product is warranted against defects that render it unfit for its reasonably intended use.
This Warranty is not extended to cover use of the product for a purpose other than as intended,