Instructions / Assembly

Step 1.1 Remove Contempo™ Fountain from its shipping carton.
Step 1.2 Adhere the Wall Spacer Pad (G) to the back of the unit as shown in Fig 1.2 below.
Step 2.1 Locate the Water Pump (A). Place the Water Pump (A) into the reservoir and run the pump power cord
through the notch behind the fountain as shown in Fig 2.1 below.
Step 2.2 Push the Flow Valve (B) into the Water Pump (A) output port as shown in Fig 2.2 below.
NOTES ON POSITIONING YOUR FOUNTAIN
a. Try to position your fountain near an electrical outlet. The fountain should not be used outdoors with the transformer
provided. Should you wish to use outdoors a pump with an outdoor rated transformer or A/C pump rated for outdoor
use.
b. When considering the location of your fountain, please consider making it easily accessible for maintenance (e.g.
adding water, cleaning etc.)
c. Consider the surface on which your waterfall will be placed. This feature can be mounted on sheetrock with wood
studs, metal studs, and can be mounted on tile or concrete. Due to the light weight nature of this fountain, it is not
necessary to mount into studs but you MUST use EZ anchors for any screw that does not hit a stud.
d. Mount indoors only. It is not recommended to place Powder Coat models in direct sunlight.
e. ** It is critical that your waterfall is level as this will ensure even water flow. **
Section1‐InitialPrepping
Section2–PumpInstallation
Fig 1.2