Instructions / Assembly

ManualsBrandsBluworld of Water ManualsOutdoorsContempo Solare Dark Copper Bronze Mirror Horizontal Fountain

635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721

www.bluworldusa.com · http://shop.bluworldusa.com

IMPORTANT–RETAINFORFUTUREREFERENCE–READCAREFULLY

1. Pleasecheckthecontentsoftheboxesbeforeattemptingtoassemblethisproduct.Afullchecklistofpartsisinthis

instructionbooklet.Checkitverycarefully.Intheunlikelyeventthatanycomponentsaredamagedormissing,pleasecontact

ourcustomerservicehotlineat407‐426‐7674.

2. Assemble

asnearaspossibletothepointofuse.Takeextremecarewhenliftingtoavoidpersonalinjuryordamagetothe

product.

3. Thisproductcontainssmallitemsandplasticbags.Pleasebeawareofthedangertoyoungchildren.

4. APencil,PhillipsScrewdriver,Level,andaMeasuring

Tapewillberequiredforinstallation.

TheContempo™Series

ASSEMBLYINSTRUCTIONS

Summary of content (8 pages)

PAGE 1
The Contempo™ Series IMPORTANT – RETAIN FOR FUTURE REFERENCE – READ CAREFULLY 1. Please check the contents of the boxes before attempting to assemble this product. A full checklist of parts is in this instruction booklet. Check it very carefully. In the unlikely event that any components are damaged or missing, please contact our customer service hotline at 407‐426‐7674. 2. Assemble as near as possible to the point of use. Take extreme care when lifting to avoid personal injury or damage to the product.
PAGE 2
Identification of Components A. Water Pump (model may vary) C. LED Light Fixture F. Reservoir Tray H. Wall Bracket B. Flow Control Valve (Inside Reservoir) D. Wire Clips E. EZ Anchor G. Wall Spacer Pad I.
PAGE 3
NOTES ON POSITIONING YOUR FOUNTAIN a. Try to position your fountain near an electrical outlet. The fountain should not be used outdoors with the transformer provided. Should you wish to use outdoors a pump with an outdoor rated transformer or A/C pump rated for outdoor use. b. When considering the location of your fountain, please consider making it easily accessible for maintenance (e.g. adding water, cleaning etc.) c. Consider the surface on which your waterfall will be placed.
PAGE 4
Fig. 2.1 Fig. 2.2 Section 3 – Light Installation Step 3.1 Locate the LED Light Fixture (C). Step 3.2 Install the LED Light Fixture (C) by sliding it down from above the fountain as shown in Fig 3.2A. The tabs need to slide into the hem as shown in Fig 3.2B and C Step 3.3 Disconnect the power cord from the LED Light Fixture (C) as shown in Fig 3.3. Run the power cord behind the bracket as shown in Fig 3.3. Step 3.
PAGE 5
Fig 3.4 Section 4‐ Mounting the Water Feature Step 4.1 Locate your level tool and draw a line on the wall indicating the top of the waterfall. Measure down from the line down approximately 8 ¾” and draw another line to indicate the center of the Wall Bracket (H). Using a level, hold the Wall Bracket (H) to the wall with the top angled towards you. Mark both mounting holes on the wall. Remember to double-check your measurements. See illustrations below. Step 4.
PAGE 6
Fig 4.2 Fig 4.3 Section 5: Operating your Fountain Step 5.1 Unwind the Water Pump (A) and LED Light Fixture (C) power cords and run the wire for the light up and over the back of the reservoir from behind the mirror As shown in Fig 5.1 . Make sure to run the LED Light Fixture (C) Light power cord behind the bracket as shown in Fig 5.1. Step 5.2 Lift your waterfall into place and engage the bracket on the back of the fountain by lowering it onto the Wall Bracket (H) as shown in Step 5.
PAGE 7
Fig 5.5 Fig 5.
PAGE 8
Warranty Bluworld’s Warranty has changed as of August 1, 2008 and supersedes all previous warranties for product purchased after August 1, 2008. If there is printed material within this shipment it is considered void and the Warranty as stated below is policy. Bluworld product is warranted against defects that render it unfit for its reasonably intended use.