Use and Care Manual

3. Dirty filter (Water Wonders units, Trellis, Bellezzas, Contempos, Watergardens, Piavascos and

Serrano Horizontal fountains do not have filters).

Remove re-usable filter from pump, clean and re-install.

4. Pump is clogged or malfunctioning

Refer to pump cleaning instructions. If still not working, unplug the fountain contact customer

service.

WATER LEAKING BEHIND THE PANEL

1. (Bluworld Fountains) Distribution bar is not fully inserted into the elbow

Turn off the water feature and carefully twist the distribution bar back and forth while applying light

pressure to ensure it is completely inserted into the elbow.

2. (Bluworld Fountains) Distribution bar o-ring gasket is misaligned

Turn off the water feature and carefully twist the distribution bar back and forth and remove the

distribution bar. Located on the distribution bar is a thin o-ring gasket. Make sure the gasket is

properly aligned and reinsert the distribution bar into the elbow.

3. (Water Wonders Fountains)Hose connection could be cut

Drain the fountain and remove it from the wall. Check the hose connection. Be sure the hose clamp

is tightened securely but not so tight that it has cut the hose. It the hose has been cut it will need to be

replaced.

4. Water flow is too strong

Locate the water flow control valve between the pump and the inlet hose. The flow valve on Water

Wonders fountains, Table Tops, Bellezzas, Piavascos and Water Gardens is a black disc located on

the top of the pump. Turn the valve clockwise to slow the water flow.

5. (Bluworld Water Fountains except Mini Moonshadow - WWMMC)Holes in the manifold are facing

the wrong direction

Rotate the manifold distribution bar until the holes are facing in the correct direction. If the water is

aimed too high on the distribution plate, it could overflow onto the backside of the fountain.

RESERVOIR IS LEAKING

Too much water

Always maintain the water level at least 2” above the water pump but ½” below the hole where the

electrical cords run through. The pump should be completely submerged underwater and should be

checked every 3 – 4 days.

SPLASHING

1. Pump is not completely submerged

The water level should be at least 2” above the pump. If the water level is too low, the pump will take

in air along with the water and will cause a spitting effect from the manifold.

2. Flow valve is not set properly

Locate the water flow control valve between the pump and the inlet hose. The flow valve on Water

Wonders fountains, Table Tops, Bellezzas, Piavascos and Water Gardens is a black disc located on

the top of the pump. Turn the valve clockwise to slow the water flow, counter-clockwise to increase

it.