Instructions / Assembly

1. Remove the Gardenfall panel from its shipping carton.
2. Lean the glass panel upright against a wall until you reach step 6.
3 Move all the packing material from the base including: the light kit, bag of river
rocks and pump/filter/valve assembly.
4 Take the valve assembly and attach it to the threaded opening on the pump by
screwing it in (figure A). Also attach the sponge filter to the threaded opening on
the side of the pump (figure B).
5. Place the assembled pump/filter/valve assembly into the reservoir with the
valve next to the side that has the hole cut out for the cord (figure C). Remove
cord strain relief (figure D). Pull the cord through the hole, leaving approximately
12 inches of the cord in the base (figure E). Apply strain relief to cord (figure F).
6. Take Gardenfall panel from step 2, and with 2 people, slide the panel into the
center of the base as shown in figure G. (Note: place cardboard over base to
protect it from scratching, do not rest the Gardenfall panel directly on the base as
this may scratch the base). It is important to place the panel in the reservoir to the
side with the plumbing coming out of the bottom.
Note: The side that has the peel-off sticker labeled "front" is the side that the
water flows down and should be facing front.
figure G
figure F
figure E
figure D
figure C
figure B
figure A
90" GARDENFALL Waterfall
90" GARDENFALL Assembly
Instructions for use
Light/Bracket with transformer (1) Pump/Filter/Valve Assembly(1)
Metal Trays for Rocks (2) Bag of River Rocks (1)
Cord Strain Relief (1) Cable Clips (5)
PARTS List
Inspect for shipping damage- any damage from shipping should immediately be reported to
the delivery agent. Do not attempt to operate if unit is damaged.
9 0 "
3 2 "
B L U W O R L D
o f w a t e r
blu

Summary of content (6 pages)