Instructions / Assembly

Open the pre-chamber B, turning counter-clockwise
(loosen the safety screw prior to this operation). Slip the
rotor D off the pump body E, taking care not to damage
the the ceramic shaft L and the supporting rubber pads
M and N. Always check the seal of the O-ring F; any
damage to the O-ring, however slight, may seriously
affect the pump performance and should be replaced.
Rinse all the parts under running water using a small
brush to remove any debris. To reassemble the pump,
perform the same operations in reversed order.
Water conditions vary greatly in all parts of the world.
Your local water conditions may cause an unwanted
build up of minerals and other deposits that may affect
the appearance and operation of your water feature.
Dependening on the level of by product present in your
local water, you may need to add the recommended
chemicals and change the water more frequently to
avoid excess build up. If these conditions are present it
is recommended to use distilled water to operate your
product. If these conditions are present and not
treated, Bluworld cannot be responsible for any effect it
may have on the water feature.
Maintenance of the PUMP
BLUW O RLD
of water
blu