Instructions / Assembly

Thank you for purchasing a Bluworld water feature. Our artistic models and superior workmanship
produce water features designed for a long-term decorative effect providing relaxing sounds and promoting
a healing environment. We hope you will enjoy your designer water feature.
IN ORDER TO CLEAN THE GLASS SIMPLY REMOVE THE HEADER AND
UNSCREW THE STAINLESS STEAL DISTRIBUTION PANEL. SLIDE THE
GLASS PANEL UPWARDS TO REMOVE IT FROM THE BASE. FILL THE BASIN
WITH WATER AND PLUG INTO A STANDARD ELECTRICAL OUTLET.
DO NOT ATTEMPT TO MOVE THE DISPLAY ONCE IT IS FILLED WITH
WATER. EMPTY THE BASIN BEFORE REMOVING FROM THE WALL.
MAINTAIN THE WATER LEVEL BY FILLING TO BELOW THE TOP EDGE OF
THE BASIN ABOUT ONCE A WEEK. WATERFALLS THAT ARE PLACED
NEAR AIR CONDITIONING VENTS AND INTAKES WILL EVAPORATE AT A
FASTER RATE. DO NOT OPERATE IF LOW ON WATER. IF HARD WATER IS
A PROBLEM IN YOUR AREA, THE USE OF DISTILLED WATER WILL
GUARANTEE THE BEST RESULTS. IT IS RECOMMENDED TO DRAIN THE
RESERVOIR ABOUT ONCE EVERY THREE MONTHS AND REFILL WITH
CLEAN WATER. BE CAREFUL NOT TO GET CLEANING AGENTS INTO THE
WATER. IF NECESSARY, WIPE THE INSIDE OF THE RESERVOIR WITH A
CLEAN CLOTH TO REMOVE ANY BUILD UP.
1. It is recommended that the water feature be left running
continuously and shut down once a week for cleaning of the
mirror or glass. Use standard glass cleaner on all surfaces of the
waterfall feature. It is also recommended that the water feature
be drained once every three to four months. After draining, wipe
the inside of the reservoir with a wet rag. It is not necessary to
use any cleaning agents to remove dirt and debris from the
reservoir. If you use soap or cleaning solutions make sure to
rinse the reservoir thoroughly before refilling it with clean water. If
not properly rinsed, this could cause foaming from the soap
residue.
2. The waterfall feature will continuously lose water due to
evaporation. Evaporation is dependent on many variables such
as climate, humidity, temperature, etc. IT IS IMPERATIVE THAT
THE WATER LEVEL BE MAINTAINED AT ALL TIMES. For the
first few months of use, you should monitor the reservoir
periodically to determine the rate of evaporation on the waterfall
feature. If a pump runs dry or very low the following can happen:
The Pump Can Burn Out And Void The Warranty
Residue May Spray Onto The Waterfall Surface
Spraying From Manifold Delivery System May Occur
3. Over a period of time, if the water in your area is hard it may
cause the glass to develop a hazy or cloudy film on its surface.
Adding a water softener such as Protec to the reservoir water will
help control hard water stains. See bottle for proper instructions
on use. It is easy to remove the hazy film from the glass
surface. When the glass is completely dry, take a dry soft cloth
and wipe or buff the surface in circular patterns.
Note: A glass cleaner only is recommended in the upkeep of
the glass surface.
4. If the unit develops an algae problem you will want to access
the reservoir through the rock tray. Algae is detected by a sour
odor and/or white gel like substance. If this occurs then add an
algaecide such as Fountec to the unit as directed. Bluworld
keeps these maintenance products in stock for your
convenience.
5. If white particles should build up on the glass it is most likely
calcium, which may be prevalent in your water supply. This may
be removed with Calcium Lime Remover (CLR). You may also
use a scraper or razor blade to remove the deposits. To reduce
maintenance on your water feature, use distilled water.
Should you experience any problems, please DO NOT
return to retailer. Instead, call 1 [phone] and
ask for Customer Service for a quick solution to
your problem.
CARE AND MAINTENANCE
GLASS/METAL WATERFALL MAINTENANCE
BLUWORLD
of water
blu