Instructions / Assembly

INSTRUCTIONS

94” and 118” Grande Water Wall

List of Parts Included:

(1) Pump

(1) Inline Filter w/ball valve and quick connect (Male)

(2) Bags of Rocks

(2) Rock Trays (one (1) if the fountain is Rear Mounted in the base)

Step 1

Stand up the water wall.

Step 2

Screw the inline filter & ball valve to your

pump.

Step3

Take the pump & connect it to the panel using

the quick connect. Male on pump, female on panel;

screw them together. Run cord out of bulk head at

back side of base. These are two holes just below

surface of base. NOTE: The lower hole/bulkhead is for

an auto drain & fill. DO NOT FILL UNIT ABOVE

THIS HOLE. The higher bulkhead is for the electrical

cord.

Step 4

Fill Unit w/ water & plug in pump. Remember:

DO NOT FILL ABOVE LOWEST BULKHEAD ON

BACK BASE.

Step 5

Adjust ball valve to appropriate flow to

maximize water flow on surface of glass without

causing splashing from the top of the fountain.

PAGE 1
INSTRUCTIONS 94” and 118” Grande Water Wall List of Parts Included: (1) Pump (1) Inline Filter w/ball valve and quick connect (Male) (2) Bags of Rocks (2) Rock Trays (one (1) if the fountain is Rear Mounted in the base) Step 1 Stand up the water wall. Step 2 Screw the inline filter & ball valve to your pump. Step3 Take the pump & connect it to the panel using the quick connect. Male on pump, female on panel; screw them together. Run cord out of bulk head at back side of base.
PAGE 2
New Warranty in effect as of August 1, 2008 Bluworld’s Warranty has changed as of August 1, 2008 and supersedes all previous warranties for product purchased after August 1, 2008. If there is printed material within this shipment it is considered void and the Warranty as stated below is policy. Bluworld product is warranted against defects that render it unfit for its reasonably intended use.
PAGE 3
Our products are warranted for a period of six months against defects in finish, pumps and other product performance issues. Light bulbs are not warranted. Our experience has shown that in practically 100% of incidents that any defect is apparent within a week of installation and use. Appearance defects should be noticed upon unpacking the fountain.